Cisco 642-832 Dumps

642-832 exam is one of the most important exam for Cisco Certification. It can prove the candidates’ professional skills and competence. The Cisco technical experts from Lead2pass have devised questions and answers for the Troubleshooting and Maintaining Cisco IP Networks (TSHOOT)candidates. This set of questions is designed to cover all the knowledge points of the Planning and Designing Cisco Superdome Server Solutions. With this test set, candidates can enhance their abilities and prepare for the exam easily. Lead2pass 642-832 will help the candidates pass the Troubleshooting and Maintaining Cisco IP Networks (TSHOOT) and get the Cisco Certification easily. It will help the candidates go further on their Cisco career path.

FCAPS is a network maintenance model defined by ISO. What does it stand for?
A. Action Management

B. Fault Management
C. Configuration Management
D. Protocol Management
E. Security Management
Answer: BCE

Which alerts will be seen on the console when running the command: logging console warnings.
A. warnings only
B. warnings, notifications, error, debugging, informational
C. warnings, errors, critical, alerts, emergencies
D. notifications, warnings, errors
E. warnings, errors, critical, alerts
Answer: C

You have 2 commands used for ftp:
ip ftp username xxxxxx
ip ftp password yyyyyy
Which two commands will be used when switching from ftp to http?
A. ip http username xxxxxx
B. ip http client username xxxxxx
C. ip http password yyyyyy
D. ip http client password 0 yyyyyy
E. ip http server username xxxxxx
F. ip http server password yyyyyy
Answer: BD

Which two of the following options are categories of Network Maintenance tasks?
A. Firefighting
B. Interrupt-driven
C. Policy-based
D. Structured
E. Foundational
Answer: BD

The following commands are issued on a Cisco router:
Router(config)#access-list 199 permit tcp host host
Router(config)#access-list 199 permit tcp host host
Router#debug ip packet 199
What would be the output shown on the console?
A. All IP packets passing through the router
B. Only IP packets with the source address of
C. All IP packets from to
D. All IP packets between to
Answer: D

You have two NTP servers & and want to configure a router to use as its NTP server before falling back to Which command will you use?
A. ntp server
ntp server
B. ntp server
ntp server primary
C. ntp server
ntp server prefer
D. ntp server fallback
ntp server
Answer: C

Welcome To Visit PassLeader