Section 1 – Choice Questions
51: Which of the following three port types are valid Spanning Tree port types? (Choose the best three answers.)
A.Designated port
B.Nonswitch port
C.Switch port
D.Nonroot port
E.Nondesignated port
F.Root port
Correct Answers: A E F
52: Which of the following is a valid method for defining a seed metric? (Choose all that apply.)
A.The default-metric command configured under the appropriate interface
B.The metric parameter in the network command of a routing process
C.The metric parameter in the redistribute command
D.The default-metric command
E.A route-map containing a seed command
F.A route map containing a metric command
Correct Answers: C D F
53: Which of the following characteristics are common to both RIPv2 and RIPng? (Choose all that apply.)
A.Link-local address used for next-hop addresses
B.Interface can be added to RIP routing process in either interface configuration mode or in router configuration mode
C.Uses a multicast to send routing updates
D.Use hop count as a metric
E.Distance-vector routing protocol
F.Maximum hop count is 15 with 16 being "unreachable"
Correct Answers: C D E F
54: Which of the following commands will enable you to see the contents of the IP routing table and send the output to a TFTP server at the same time?
A.show ip route | to tftp://192.168.1.1/route.txt
B.show ip route | tee tftp://192.168.1.1/route.txt
C.show ip route | include tftp://192.168.1.1/route.txt
D.show ip route | include tJtp://192168.1.1/route.txt
E.show ip route | redirect tftp://192.168.1.1/route.txt
Correct Answers: B
55: Which of the following solutions will encapsulate IPv6 packets with IPv4 headers?
A.Create an IPv4 tunnel and assign the tunnel IPv6 addresses.
B.Create IPv4 interfaces on both ends of the network, and use either static routes or a routing process to direct IPv6 packets through those interfaces.
C.IPv6 packets cannot be encapsulated with IPv4 headers because the addresses are not compatible.
D.Create IFV6 interfaces on both ends of the network, and use static routes to point the IPv4 address to those interfaces.
E.Use an IPv6 routing protocol like OSPFv3 and assign IPv4 packets to that process.
F.Create an IPv4 tunnel and use the tunnel mode ipv6ip command.
Correct Answers: F
